Subscribe
Subscribe

Dust Advisory issued April 27 at 7:28PM MDT until April 27 at 8:15PM MDT by NWS Albuquerque NM

StormPrep

The National Weather Service in Albuquerque has issued a

* Dust Advisory for…
Lincoln County in central New Mexico…
Southwestern Chaves County in southeastern New Mexico…

* Until 815 PM MDT.

* At 728 PM MDT, satellite data indicated widespread areas of
blowing dust were located over most of Lincoln and southwest
Chaves Counties.

HAZARD…Less than two miles visibility.

SOURCE…Radar indicated.

IMPACT…Hazardous travel.

* Locations impacted include…
Ruidoso, Carrizozo, Lincoln, Ruidoso Downs, Capitan, San Patricio,
Hondo, Lincoln State Monument, Glencoe and Tinnie.

This includes Highway 380 between Mile Markers 52 and 107.

Related Posts

Small Craft Advisory issued April 30 at 10:30PM EDT until May 1 at 5:00AM EDT by NWS Key West FL

* WHAT...Northeast to east winds near 20 knots. Seas up to 7 feet in the Straits of Florida. * WHERE...Straits of Florida, Hawk Channel, Gulf waters including the Dry Tortugas, and Florida Bay. * WHEN...In Effect. * IMPACTS...A Small Craft Advisory means that wind speeds of 20 to 33 knots, or seas of 7 feet or greater, are expected to produce hazardous conditions for small craft. These hazardous conditions may result in poor vessel handling and steering response, broaching, overturned dinghies and kayaks, slips and falls on slippery decks, rub damage along docks and seawalls, swamped bows at reef tract
StormPrep

Marine Weather Statement issued April 30 at 6:13PM AKDT by NWS Juneau AK

A strong low will position itself in the eastern gulf late Wednesday, with sustained southerly strong breezes increasing to gale force overnight Wednesday into Thursday morning for Clarence Strait. Expect winds to slowly diminish later Thursday evening. A brief period of gales may develop for Stephens Passage and Fredrick Sound, mainly localized near Five Finger. Likelihood of short term gales Thursday morning have increased, but are still around 30%.
StormPrep

Leave a Reply

Your email address will not be published. Required fields are marked *